Il circuito di interfaccia deve ess

Il circuito di interfaccia deve essere collegato al modulo secondo lo schema di connessione 1 mostrato nella Appendice C - (Fig. 2)

Ogni carattere che si trasmette al modulo P2KH viene ritrasmesso indietro.Ciò serve alla verifica e alla sincronizzazione tra master e slave.Il P2KH non sempre è disponibile alla ricezione dei dati seriali , soprattutto durante il funzionamento.


IMPORTANTE: Quasi tutti i comandi possono essere inviati dal programma di HyperTerminal di Windows.

결과 (영어) 1:

the interface circuit must be connected to the module according to the connection diagram shown in Appendix c 1 - (Fig. 2)

every character that is transmitted to the module p2kh is retransmitted indietro.ciò serves to the verification and synchronization between master and slave . the p2kh is not always available to receive serial data, especially during operation.


important:almost all of the commands can be sent from the program hyperterminal windows.

결과 (영어) 2:

The interface circuit must be connected to the module according to the connection diagram 1 shown in Appendix C – (fig. 2)

each character that is transmitted to the module P2KH is retransmitted back.This serves to check and synchronization between master and slave.The P2KH is not always available to receive serial data, especially during operation.


important: Almost all commands can be sent from the HyperTerminal program in Windows.

결과 (영어) 3:

The interface circuit must be connected to the module according to the diagram of the connection 1 shown in Appendix C - (Figure 2)

each character that is transmitted to the module P2KH is retransmitted indietro.ci or serves to verify and to the synchronization between the master and slave.il P2KH is not always available to receive serial data , especially during operation.


IMPORTANT:Almost all the commands can be sent from HyperTerminal program Windows.