Questo documento descrive le modali

Questo documento descrive le modalità per comunicare con il modulo P2KH.
 L‟interfaccia seriale è di tipo :
Asincrono , 1 bit start , 1 bit stop , 8 data bit,no parità e 9600 bit/sec.
 I messaggi inviati al modulo P2KH devono essere stringhe con il codice (0D esadecimale)
 Prima di iniziare è necessario assemblare il circuito di interfaccia suggerito nella Appendice B - Fig.1
 Il circuito di interfaccia deve essere collegato al modulo secondo lo schema di connessione 1 mostrato nella Appendice C - (Fig. 2)
 Ogni carattere che si trasmette al modulo P2KH viene ritrasmesso indietro.Ciò serve alla verifica e alla sincronizzazione tra master e slave.Il P2KH non sempre è disponibile alla ricezione dei dati seriali , soprattutto durante il funzionamento.
IMPORTANTE: Quasi tutti i comandi possono essere inviati dal programma di HyperTerminal di Windows.

결과 (영어) 1:

This document describes how to communicate with the module p2kh. 
l "serial interface is of type:
asynchronous, 1 start bit, 1 stop bit, 8 data bits, no parity and 9600 bits / sec.
 messages sent p2kh module must be strings with the code (0d hex)
 before you start you need to assemble the interface circuit suggested in appendix b - Fig.1
 the interface circuit must be connected to the module according to the connection diagram shown in Appendix c 1 - (Fig. 2)
 any character that is transmitted to the module p2kh is retransmitted indietro.ciò serves to the verification and synchronization between master and slave.il p2kh is not always available to receive serial data, especially during operation.
important:almost all of the commands can be sent from the program hyperterminal windows.

결과 (영어) 2:

This document describes how to communicate with the module P2KH.
 serial interface is of type:
1-bit asynchronous start, 1 stop-bit, 8 data bits, no parity, and 9600 bits/sec.
 messages that are sent to the P2KH module must be strings with the Code (0 d hex)
 before you start you need to assemble the interface circuit suggested in Appendix B-fig. 1
 The interface circuit must be connected to the module according to the connection diagram 1 shown in Appendix C – (fig. 2)
 each character that is transmitted to the module P2KH is retransmitted back.This serves to check and synchronization between master and slave.The P2KH is not always available to receive serial data, especially during operation.
important: Almost all commands can be sent from the HyperTerminal program in Windows.

결과 (영어) 3:

This document describes how to communicate with the module P2KH.
 L'serial interface is of type :
Asynchronous , 1 start bit, 1 stop bit, 8 data bits, no parity and 9600 bit/sec.
 messages sent to the module P2KH must be strings with the code (0D hex)
 Before you begin, you must assemble the interface circuit suggested in Appendix B - Fig.1
 The interface circuit must be connected to the module according to the diagram of the connection 1 shown in Appendix C - (Figure 2)
 each character that is transmitted to the module P2KH is retransmitted indietro.ci or serves to verify and the synchronization between master and slave.il P2KH is not always available at the reception of the serial data, especially during operation.
IMPORTANT:Almost all the commands can be sent from HyperTerminal program Windows.